Dry Type Transformer

(10 KVA to 5000 KVA) - up to 33 KV

The dry type Transformer is of two types. They are:

1.) Cast Resin Dry Type Transformer (CRT): Cast resin dry type transformer (CRT) is used in high moisture prone areas. Primary and secondary windings are encapsulated with epoxy resin...

This type of transformer has some featured advantages. They are:

  • Better overload capacity
  • Low partial discharge, high efficiency
  • Zero fire risk due to non-inflammable winding
  • Can be used outdoors in IP45 enclosure
  • Non-hygroscopic
CRT Transformer

2.) Vacuum Pressure Impregnated Transformer (VPI): Uses minimal flammable material as insulation...

This type of transformer has several advantages. They are:

  • High mechanical strength
  • Void-free insulation
  • No temperature fluctuation
  • Easy maintenance
  • Less fire risk
VPI Transformer

Advantages & Disadvantages

Advantages of Dry Type Transformer: The main advantages of dry type transformer are given below.

  • Safety for people and property
  • Maintenance and pollution-free solution
  • Easy installation
  • Side clearance is less
  • Environmentally friendly
  • Excellent capacity to support overloads
  • Reduced cost on civil installation works and fire protection systems
  • Excellent performance in case of seismic events
  • No fire hazard
  • Excellent resistance to short circuit currents
  • Long lasting due to low thermal and dielectric heating
  • Suited for damp and contaminated areas

Disadvantages of Dry Type Transformer: But there are some disadvantages of dry type transformer.

  • Dry type transformer is long lasting and with less chance of winding failure. But once it fails whole setup is to be changed, i.e. complete change of high voltage and low voltage winding with limb.
  • For same power and voltage rating, dry type transformer is costlier than oil cooled transformer.

Application of Dry Type Transformer

Dry type transformer are widely used in:

  • Chemical, oil and gas industry
  • Environmentally sensitive areas (e.g. water protection areas)
  • Fire-risk areas (e.g. forests)
  • Inner-city substations
  • Indoor and underground substations
  • Renewable generation (e.g. off-shore wind turbines)

Send the Request